Winndscreen washer jets
One jet blocked as blocked can be, tried the needle approach without success. does the block with the two jets remove easily or is there another way, small drill bit maybe ?
tried an air line.
If you don't have an air line try a single strand of wire brush. Pull it out with a pair of pliers and do the honours. Normally works quite well unless the jet has been blocked for a long period of time.
Kind regards
Peter
put it in a pan and boil it up!
simon
Had some blockage on mine from a dirty tank earlier on, it is very annoying when just on one side! Anyway long story short I bought a new one and the improvement is immense..only clean the tank before you fit it so you don't repeat the problem again!
Can't quite remember the cost, but was near £12 I think?
Remember this one's heated and all...
The nozzle does remove from the bonnet fairly easily. You need to remove the electric cable and water pipe.
Rummage through Dawny's sewing basket until you find a needle of the correct size to slid right inside the nozzle. It should go in 5mm or so. Also stick an airline on it from both sides. I used a tyre pump with various adapters and blew it all clean. The nozzles should be free to move around too
Jus had he same problem on ours. Failed to clean / unblock it. Got one off a scrap 190, £2 and exactly he same :D :D
Russ
JOIN THE GWOA
This website and forum are provided for the benefit of enthusiasts and owners of all Mercedes Benz off road vehicles, in particular the G Wagen. The costs of development, upkeep and provision of the site are met entirely by the annual subscriptions of club members. If you are using the site and are not a member of the G Wagen Owners Association please consider joining. You will have access to areas on the site that are not open to non members, to club trips and meetings and to technical assistance. In addition your contribution (only £25 annually) will help us maintain and develop our website for future users.
Who's new
- Jaffa_JIM_23
- Wrabstar
- GG
- KTMSCANIA22
- 280ge
